hey guys, im having problems with my v-tec cutting on and off.. Ill be driving and get above 5000rpms and the v-tec will sometimes engage and sometimes it wont.. or it will engage and then cut out.. I checked the vtec selonoid screen and there wasent anything wrong there, also changed the TPS becasue i was getting code 7 reset it by pulling the haz fuze out for 5 min and re installing and drove it for a day to work and back and around town and no code but the damn vtec still is acting stupid.. Its kinda got me pissed off, i dont know what else to check... Its got new oil and filter runs 70- 76lbs press while driving, Im running 5W30 castrol full syntec with a K&N oil filter.. also the distributer and cap plugs and wires, fuel filter are all new

Woulld being low on tranny fluid cause this, my trany leaks a little at the seal so it might be low on fluid ( dont know were to fill it need help on that also its a jdm b16a motor not sure of what trany it has ) Im kinda doughting it but hell i dont know im willing to try anything..

ok.. I was on google looking for my problem on there.. my car 88crx the speed is also off on it.. it says im going 15mph faster then i really am.. i just thought that it was because ive got 16 inch rims on it.. and that it prob has the wrong speed cable going to the trany form who ever done the motor swap. could maybe the speed sensor be causing this.. only thing is I dont get a Check Engine Light