warbly right side - Page 2 - Tuner-Junction

d3f4ult · #21 (**permalink**) December 2nd, 2007, 03:21 AM

It honestly depends on the generation your engine came out of.

OBD0 Honda's had the map on the firewall, which is where your SI harness is trying to reach. OBD1 Honda's have them built onto the top of the throttle body, in that case, you need to add about a foot of wire to your map sensor connector, and then it will reach and connect without issues.

If you add wire, I strongly recommend solder/heatshrink, or non-insulated butt connector, a good pair of crimpers, and heatshrink. Also, purchase some more loom to keep that -- Fresh from the factory -- look =)

Let me know if I can help out anymore bro. That's what we are here for

Dave

drummingpariah · #22 (**permalink**) December 3rd, 2007, 04:22 PM

Quote:

Originally Posted by d3f4ult

It honestly depends on the generation your engine came out of.

OBD0 Honda's had the map on the firewall, which is where your SI harness is trying to reach. OBD1 Honda's have them built onto the top of the throttle body, in that case, you need to add about a foot of wire to your map sensor connector, and then it will reach and connect without issues.

It came out of a '91 obd0 integra rs, so it should fit right up. I'm not sure why I thought it wouldn't fit (I may even have some pictures lying around) but I remember something like the wire clips not lining up (d16a6 car-side wiring harness to the b18a1 map sensor clip)