ey guys, this is crx specific so Im going to post here. Im looking for the wiring harness that goes from the ecu to the connectors in the engine bay(underdash harness?). I need it from the Si. The person that did the b16 swap before me, hacked up the wires to convert it for the pr3 and I want to clean it up when I switch it to obd1. So I need to convert it back to stock and then I can run the ecu adapters, thanks.

__________________

I would try some junk yards, or even fleabay!
I have found lots better beals at junk yards than anywhere else
Todd

How can you be running a PR3 that's not OBD-1? I have that setup and I just got a Boomslang harness for $120

__________________

R y w i r e . c o m - G e t _ R y w i r e d .
Engine Swap Wire Harness Conversions and ECU Conversion Harnesses
My parts for sale

PR3's only came as non obd(to the best of my knowledge), two single wire o2 sensors, etc.... Ive been trying ebay, I actually havnt found any yet kinda surprised but yea junkyards are my next stop.

__________________