I have a couple things just lying around my garage that I need to get rid of.
D15b2 block $50
PM5 manifold $10
Stock DX exhaust manifold $30 (too heavy to ship)
D - series flywheel $5
Stock DX seats, have rips - $5
Stock JDM EF8 seat rails (direct bolt-in for 88-89 EF's) $5

Stock CRX battery $10 had an extra one handy during the swap just in case.
Spare tire - $5
Stock 13" steelies with some old tires - $40

PM6 manifold with injectors and throttle body and fuel line......most sensors. $70
Stock CRX shift linkage $20
A6 OBD0 dizzy (bought for a project that never happened. I was told it worked but I've never used it) $55 shipped
PM5 ECU $25 shipped
D series axles that were about a year old when i removed them. $50 for both.
Stock crossmember $50
Stock hood......good shape and clearcoat sanded off, minor ding (pick up only or will meet within reasonable distance $50 obo)
Dual (brand) headunit. Plays mp3's. No remote and face doesn't detach. $30
Pioneer speakers for the front that mount perfecty in a CRX door. $20
Sony xplode speakers for the rear along with the rear speaker brackets. $50 including brackets

EF8 headlights with bulbs and plugs for bulbs. Headlights are in good shape. $110 shipped



EF8 bumper lights. Tabs are broken off on both but still usable. Small cracks in them $50 shipped

Complete AC system. It had been previously working but I believe I ran out of freon. I don't know how to verify that the compressor is good or bad. If you know then I'll test it. It just stopped blowing cold air one spring day. When i removed it for the swap it was completely empty. $65

ITR flywheel (I need to weigh it to verify, but it came on my motor) $75
OBD2 itr dizzy $100 shipped

I only have pics of the headlights and my camera recently broke (junk Nikon). I'l post pics of hte lights later. I'm not sure on the prices so just pm me offers. Low balling . I might have some more stuff lying around but I'll have to check.

Everything is OBO! I really want to clear this stuff out.
Thanks

__________________
~Will

88 CRX DX + 97 Spec JDM B18c(R) + some suspension goodies = Lots of fun!

JDM 4.785 final drive, ACT HDSS and Prolite 8lb flywheel, K&N, Kteller 2.5 w/magnaflow, NGK, Distributor King, Fiberimages, Koni, Neuspeed, ST rear 22mm sway bar with ITR LCA's, Konig Heliums, Russel's Brake Lines, Rywire Harness w/JKOBD, Hasport Hydro EFB2 Mounts and Linkage, Phearable.net P28, Full-Race

Ill give ya 20$ for driver side axle if the boot is good.

Where are you located?

__________________